Clarke CS4-6C Manuale di Servizio

OPERATION & MAINTENANCEINSTRUCTIONSLS1109BELT & DISC SANDERMODEL NO: CS4-6DPART NO: 6500412

10CHANGING THE SANDING BELTS1. Loosen the socket head screw using the 6 mm hex wrench provided.2. Raise the belt sanding arm as shown.3. Slide out one

11BELT TRACKINGThe belt-tracking adjustment is set at the factory so that the abrasive belt will run true on the drums. If, however, the belt should t

12OPERATIONON/OFF BUTTONSThe On/Off buttons are located on the front of the sander.1. Press the GREEN button (I) to turn the sander on. 2. Press the

13SURFACE SANDING ON THE BELTWhen sanding flat broad surfaces on the belt hold the workpiece firmly on the surface of the belt and against the backsto

14MITRE GAUGE - DISC SANDERA mitre gauge can be used on the work table, as shown. The mitre gauge head can be set anywhere up to 60o (right or left) b

15SPECIFICATIONSPARTS AND SERVICINGMotor 230V, 50Hz, 1phInput Power 370 WattsFuse Rating 13ASanding Disc Diameter 6” (150 mm)Sanding Belt Size (W x L

16EXPLODED DIAGRAM & PARTS LIST

17EXPLODED DIAGRAM & PARTS LISTNO DESCRIPTION PAR T NO1 Philips Screw M4x6 AWNCS46D012 Flat Washer D4 AWNCS46D023 Base Cover AWNCS46D034 Philips

18EXPLODED DIAGRAM & PARTS LIST73 Bearing Base AWNCS46D7374 Phillips Screw M6x25 AWNCS46D7475 Hex Socket Round Head Screw M8x25AWNCS46D7576 Bel

19DECLARATION OF CONFORMITY

2INTRODUCTIONThank you for purchasing this CLARKE product.Before attempting to use this product, please read this manual thoroughly and follow the ins

3GENERAL SAFETY RULES 1. ALWAYS learn the machines applications, limitations and the specific potential hazards. Read and become familiar with the ent

415. NEVER operate machine while under the influence of drugs, alcohol or any medication.16. NEVER leave machine running unattended. Turn power off. D

5ELECTRICAL CONNECTIONSBefore switching the product on, make sure that the voltage of your electricity supply is the same as that indicated on the rat

6OVERVIEWSanding operations are inherently dusty. It is strongly recommended that users use a dust-collection system when using this belt & disc s

7ASSEMBLYMOUNTING THE SANDER TO A WORKBENCHBefore attempting to use this sander, it should be properly mounted to a workbench or stand1. Position the

8INSTALLING THE BACKSTOP1. Position the backstop against the belt frame so that the slot aligns with threaded hole in frame.2. Secure the backstop to

9CHANGING THE SANDING DISCS1. Remove mitre gauge and work table assembly. 2. Remove the disc guard screws and disc guard.3. Remove sanding disc from d